New Features

This section describes some of the new features in release 1.6.

AWID MPR

- The AWID now uses TCP to connect instead of Serial. - Several new commands have been added, including Gen2 Portal. - There is now a welcome message providing information about the reader at startup. - The reader will no longer crash if an invalid command is sent. - Fixed an issue where requesting the temperature would cause the reader to crash.

Alien

- Speed and RSSI are now supported features for tags. - Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off" - Several Autonomous commands are fixed so they work properly. - Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read. - GPIO is now enabled by default. - Time commands now work for the Alien.

LLRP

- Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation. - Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. - Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled. - Fixed a conversion error for a short in _C1G2ReadOpSpecResult