Difference between revisions of "Emulator 1.6"
From RifidiWiki
(New page: =New Features= This section describes some of the new features in release 1.6. ==AWID MPR== - The AWID now uses TCP to connect instead of Serial. - Several new commands have been added, ...) |
|||
| Line 13: | Line 13: | ||
- Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off" | - Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off" | ||
- Several Autonomous commands are fixed so they work properly. | - Several Autonomous commands are fixed so they work properly. | ||
| + | - Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read. | ||
==LLRP== | ==LLRP== | ||
| + | |||
| + | - Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation. | ||
| + | - Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. | ||
| + | - Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled. | ||
Revision as of 23:28, 9 November 2009
Contents
New Features
This section describes some of the new features in release 1.6.
AWID MPR
- The AWID now uses TCP to connect instead of Serial. - Several new commands have been added, including Gen2 Portal. - There is now a welcome message providing information about the reader at startup.
Alien
- Speed and RSSI are now supported features for tags. - Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off" - Several Autonomous commands are fixed so they work properly. - Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read.
LLRP
- Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation. - Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. - Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled.
