Revision as of 23:50, 9 November 2009

New Features

This section describes some of the new features in release 1.6.

AWID MPR

• The AWID now uses TCP to connect instead of Serial.
• Several new commands have been added, including Gen2 Portal.
• There is now a welcome message providing information about the reader at startup.
• The reader will no longer crash if an invalid command is sent.
• Fixed an issue where requesting the temperature would cause the reader to crash.

Alien

• Speed and RSSI are now supported features for tags.
• Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off"
• Several Autonomous commands are fixed so they work properly.
• Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read.
• GPIO is now enabled by default.
• Time commands now work for the Alien.

LLRP

• Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation.
• Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command.
• Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled.
• Fixed a conversion error for a short in _C1G2ReadOpSpecResult

Sirit

• Added support for the Sirit reader to emulator.