Difference between revisions of "Emulator 1.6"
From RifidiWiki
| Line 7: | Line 7: | ||
- Several new commands have been added, including Gen2 Portal. | - Several new commands have been added, including Gen2 Portal. | ||
- There is now a welcome message providing information about the reader at startup. | - There is now a welcome message providing information about the reader at startup. | ||
| + | - The reader will no longer crash if an invalid command is sent. | ||
| + | - Fixed an issue where requesting the temperature would cause the reader to crash. | ||
==Alien== | ==Alien== | ||
| Line 14: | Line 16: | ||
- Several Autonomous commands are fixed so they work properly. | - Several Autonomous commands are fixed so they work properly. | ||
- Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read. | - Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read. | ||
| + | - GPIO is now enabled by default. | ||
| + | - Time commands now work for the Alien. | ||
==LLRP== | ==LLRP== | ||
| Line 20: | Line 24: | ||
- Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. | - Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. | ||
- Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled. | - Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled. | ||
| + | - Fixed a conversion error for a short in _C1G2ReadOpSpecResult | ||
Revision as of 23:31, 9 November 2009
Contents
New Features
This section describes some of the new features in release 1.6.
AWID MPR
- The AWID now uses TCP to connect instead of Serial. - Several new commands have been added, including Gen2 Portal. - There is now a welcome message providing information about the reader at startup. - The reader will no longer crash if an invalid command is sent. - Fixed an issue where requesting the temperature would cause the reader to crash.
Alien
- Speed and RSSI are now supported features for tags. - Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off" - Several Autonomous commands are fixed so they work properly. - Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read. - GPIO is now enabled by default. - Time commands now work for the Alien.
LLRP
- Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation. - Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command. - Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled. - Fixed a conversion error for a short in _C1G2ReadOpSpecResult
