Fail-over Configuration (Primary/Secondary)

From RifidiWiki

Jump to: navigation, search

Introduction

Starting in 3.1 Failover Configuration (Primary/Secondary) feature is available.

This enables a Rifidi Edge server to be defined as a secondary node based on configuration described below. The secondary server will start and load the basic libraries. In the event a failure is detected based on thresholds configured the server will continue to load the necessary Rifidi Apps and connecting to the required sensors/readers to continue processing events.

Note: Many RFID readers only allow for one connection hence the reason for a primary and secondary node configuration to ensure only one connection by a Rifidi server node configuration .

Configuration

rifidiserver.ini in windows and rifidi-server in linux/unix -- A full list of Rifidi Edge configuartion parameters can be found Edge_Server_Configuration


Example Edge Sever Configuration required to support Failover

-Dorg.rifidi.failover.primary=192.168.0.12:8111    IP and Port of the Primary Edge Server
-Dorg.rifidi.failover.frequency=10                 how often to call The Primary Server's rest ping command in seconds
-Dorg.rifidi.failover.failurecount=6               number of consecutive failures before secondary determines the primary has failed

Note: The Port number (8111 in this example which is also the default Restlet port) needs to match Restlet port # on primary server found in the [[Edge_Server_Configuration|Edge_Server_Configuration]]

These settings will cause the server to act as a secondary node and try to connect to the primary, getting the "readers" command every 10 seconds. 6 failures in a row will mean the application launch will continue on.

Personal tools