Difference between revisions of "Fail-over Configuration (Primary/Secondary)"
From RifidiWiki
(→Configuration) |
(→Configuration) |
||
| Line 11: | Line 11: | ||
*-Dorg.rifidi.failover.primary=192.168.0.12:8111 as example -if set then means its secondary if null of not set then primary | *-Dorg.rifidi.failover.primary=192.168.0.12:8111 as example -if set then means its secondary if null of not set then primary | ||
node | node | ||
| − | Note: | + | '''Note: Port number needs to match Restlet port # on primary server (-Dorg.rifidi.restlet.port=8111)''' |
*-Dorg.rifidi.failover.frequency=10 - how often to call rest ping command in seconds | *-Dorg.rifidi.failover.frequency=10 - how often to call rest ping command in seconds | ||
*-Dorg.rifidi.failover.failurecount=6- number of consecutive failures | *-Dorg.rifidi.failover.failurecount=6- number of consecutive failures | ||
Revision as of 09:10, 15 October 2014
Introduction
Starting in 3.1 Failover Configuration (Primary/Secondary) feature is available.
This enables a Rifidi Edge server to be defined as a secondary node based on configuration described below. The secondary server will start and load the basic libraries. In the even a failure is detected based on thresholds configured the server will continue loading starting the necessary Rifidi Apps and connecting to the required sensors/readers to continue processing events.
Configuration
In rifidiserver.ini - In rifidiserver.ini - A full list of Rifidi Edge configuartion parameters can be found Edge_Server_Configuration
JVM settings - Full ListEdge_Server_Configuration
*-Dorg.rifidi.failover.primary=192.168.0.12:8111 as example -if set then means its secondary if null of not set then primary node '''Note: Port number needs to match Restlet port # on primary server (-Dorg.rifidi.restlet.port=8111)''' *-Dorg.rifidi.failover.frequency=10 - how often to call rest ping command in seconds *-Dorg.rifidi.failover.failurecount=6- number of consecutive failures
These settings will cause the server to act as a secondary node and try to connect to the primary, getting the "readers" command every 10 seconds. 6 failures in a row will mean the application launch will continue on.
