Emulator 1.6
From RifidiWiki
Contents
New Features
This section describes some of the new features in release 1.6.
AWID MPR
- The AWID now uses TCP to connect instead of Serial.
- Several new commands have been added, including Gen2 Portal.
- There is now a welcome message providing information about the reader at startup.
- The reader will no longer crash if an invalid command is sent.
- Fixed an issue where requesting the temperature would cause the reader to crash.
Alien
- Speed and RSSI are now supported features for tags.
- Now allows both ON/OFF and 1/0 to be used for commands that toggle between "on" and "off"
- Several Autonomous commands are fixed so they work properly.
- Fixed a problem with the "antennasequence" command that sometimes caused no tags to be read.
- GPIO is now enabled by default.
- Time commands now work for the Alien.
LLRP
- Fixed a problem with ROSpecs accepting an invalid ID number as valid during creation.
- Fixed an exception that sometimes occurred when sending a SET_READER_CONFIG command.
- Fixed a problem where sometimes a ROSpec wouldn't start again after being disabled.
- Fixed a conversion error for a short in _C1G2ReadOpSpecResult
Sirit
- Added support for the Sirit reader to emulator.