Version 1.3.1

From RifidiWiki

Jump to: navigation, search

Version 1.3

Be sure to check out the changelog in Version 1.3 if you haven't seen it already!

Changes in 1.3.1

New subscriber mode added

A new subscriber mode was added so that a tag showing up on different antennas or different readers which has previously been seen before the timeout on other antennas or readers that are all in the same readzone will NOT create a new arrival event. For instance, in the old system:

A readzone was defined for reader LLRP_1 and antennas 1, 2, and 3. Tag A shows up on antenna 1, generating an arrival event. Then, the tag leaves antenna 1 and moves to antenna 3. Under the old system, a new arrival event would be generated at antenna 3. If you wish, you can set it so that a new arrival event does not get generated. The same thing will happen if multiple readers are specified for the same readzone and the tag shows up on a new reader.

GPIO support added for LLRP

LLRP added GPIO support now, so you can test GPI ports and set GPO ports on an LLRP reader from within a RifidiApp.

Performance increased for the default ReaderConfig for LLRP

The performance of the ROSpec submitted by the ReaderConfig in PUSH mode for LLRP has been increased by default. For deployments the ADD_ROSPEC_From_File command is still recommended, but the diagnostic capabilities of the PUSH ReaderConfig of the LLRP are now improved.

LLRP Bug Fixed

Occasionally certain tags (particularly non-standard tags) would show up from the LLRP arrival queue in binary instead of hexidecimal. This has now been fixed and all LLRP tags should now display correctly.

Links

Javadocs: http://www.transcends.co/www/javadoc/edge1.3.1/

Personal tools